It can also create packages right out of existing installed software (Programs and Features) in under 60 seconds! Read more about Package Builder. If you are doing this for yourself, then it could override any time-savings you get as a consumer using Chocolatey and the community repository.įor organizations, we've developed Package Builder, which creates full software deployments (packages) in 5-10 seconds. This is desired when you want to manage software offline as most things on the community repository are subject to copyright law and distribution rights (why they don't simply have the software they represent embedded).Ĭreating and working with your own packages is very secure, but it does tend to take up time. Create Your Own Packages - Betterįor packages you need offline, you have the ability to manage your own packages and you can embed software right into the package. ![]() NOTE: The cache will only support the same architecture, as in you can't take the results from an 圆4 machine and expect the cache to have 32-bit installers also downloaded. See choco config, choco config -h and choco config set cacheLocation c:\some\location to do this. You can also override the cache location, so that the folder is somewhere not in TEMP. While there are ways to set the original nupkg (with the version on it, not the one in the packages directory - use download from left side of packages page on the Chocolatey community package repository) and preset the downloaded binaries into the cache folder, it's not always deterministic that it will work. This is not a limitation when using Chocolatey internally. Typically package maintainers on the community package repository do not have distribution rights for the actual software binaries, so the package needs instructions to go download those resources and act on them. You can do this manually or look at Chocolatey for Business to do this. We've updated this question based on content at Sources can be one of the following formats: Will research it further.įirst let's address a misconception. My experience with Homebrew gives me a clue that if Chocolatey stores the downloaded packages, I could just manually take them from the storage path on one PC and put to that path on the other one. Running a server for a single use is an overkill for this task. ![]() However, it expects a URL and not a local path. UPD: Probably there's a way to achieve this by using a custom nfig, where I explicitely change source. So, is there a way to do such a trick with chocolatey? But there are quite a lot packages (around 20) and I really, really like the UNIX way of doing things. Yes, I could just download installers one-by-one and then install them consecutively. I'd like to download a bunch of chocolatey packages and later install them on another PC (which has a bad internet connection, so I cannot just install them in a usual way).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |